Search results

Sorry about that. Vitamin c tablets.

We are on a well and have noticed some rust spotting in our pool and have been removing with tablets. We have an auto fill from our well that is introducing rust. Could I put a tablet in the autofill bucket each week to prevent the spots?

Brushing pool the other day and I found small spots (about an inch) that are rust colored. We have an autofill from our well that has red iron. Any advice on treatment for the spots as well as a continual way to prevent them from returning?

Wanted to update with some success in not having to drain my pool 40% as recommend to balance salt! My salt reading according to our local store was actually 6500! I drained pool 12 inches (18,000 gallon). I put two hoses to begin refilling right in front of my two main drains and secured them...

Thanks guys for the replies. I was wondering if I diluted the water going into the SWG by placing the hose in the skimmer (which I would close main drain and leave this as only return to the pump). If this flow of partial pool water partial hose water would allow the swg to convert. I was...

Ended up with way to much salt in our pool 5800 according to our automation the store said 6500. If I were to open only the skimmer add a garden water hose in it and super chlorinate would that work to lower the level to produce again? Could this process harm anything? We are in Fl with a high...

Led deck jets installed and bubbler chipped out They really struggled with bubbler in addition to having to chip it out the shotcrete caught a bunch of the wire inside the concrete as well. Hope this will still function good. Deck jets seemed to be pretty labor intensive to set as...

Ok just wanted to make sure. We already have price set for the two colors, but right now on that lip of sun shelf there is a line of tile what we are afraid may have our pool looking too busy. Was wondering if there were any other methods to have these two finishes be separate without having the...

No, wasn't sure if any pool buyers had this done and had any suggestions on how it was done. Should I check forum rules, am I not suppose to ask questions like this?

Yea he seemed unsure, but said he would make some calls. Wanted to see if anyone had experience with bubblers added after shell is in.

The bubbler will be place on the top of this shelf

Is it possible to have a sand pebble finish on the top of this shelf and a blue pebble finish on the wall of shelf without a boarder tile?

Is it possible? Shotcrete was in last week and our pool bubbler is about 3 ft off center. We suggested adding another to offset the unsymmetrical bubbler. What would be the process for this so I could maybe pass it along? Thanks, Mark

Also ceramic vs porcelain for underwater application?

Anyone have any recommendations for an online site to order mosaics?

....

Waiting to talk to him. Once it's chipped out and centered in pool its not longer centered on our patio because the entire pool is in wrong spot.

....

(The yellow cord is from edge to bubbler) (this yellow cord is the same measured distance as the first pic yet not anywhere close to the bubbler because the pool is off center. The sprinkler is where the bubbler starts)

Thank you. (The yellow ext cord is the actual center of french doors)

....

Re: A few off measurements after pool was shot. This is the widest picture I can get. I am just concerned that because the pool was not centered now the umbrellas and bubbler are off and may not look good.

Does this help? I edited my initial post some too.

So our pool shell was just shot and the pool was supposed to be centered between the two columns in photograph. The bubbler in picture is somewhat centered with our door to the pool (ext cord is center point), but since the pool is off by this measurement so is the bubbler. It is about 2-3ft...