Recent content by cubbienate

Pool is looking great! Hope you guys get to enjoy all of that work soon! Sent from my SM-G920V using Tapatalk

This is a link to the fence that was used. http://www.menards.com/main/building-materials/fencing/utility-fencing/vinyl-and-vinyl-coated-fence/3-x-25-plastic-poultry-netting/p-1444451731659-c-5770.htm?tid=5583501460095339276

Mike, That's what the plans called for. The deck is less then 4 feet off the ground so bigger was not nessary. Atleast that's what I was told. Sent from my SM-G920V using Tapatalk

I found that netting by the chicken wire fence at the hardware store. I liked it because it was plastic. I will see if I have a name when I get back on Wed. Think it was from Menards. Sent from my SM-G920V using Tapatalk

Yay!! Congrats on getting to enjoy the pool! Sent from my SM-G920V using Tapatalk

Did landscaping around the pool all day and then had enough and jumped in! Pool was 84 degrees today! Sent from my SM-G920V using Tapatalk

We have about 3-4 foot access under the deck. You can frame the pool with decking and then you can remove those pieces if you need to. We almost did but I figure I will just remove a few deck boards if needed. Our deck goes up to the cap so we would just need access to the post caps to remove...

Take a look at my setup. Union is the bigger round pieces. Just make sure to get schedule 40 connectors Sent from my SM-G920V using Tapatalk

Check pool math but with mine I just dumped a gallon of bleach in while I was setting up and just checked every few days. If you put unions on the end of those pipes you can always redo the pipes later even if you don't have all the valves. They also make connectors to go from flex to PVC. That...

Do you have all of the parts that came with the pump, filter and SWG? I am not an expert but the SWG might be undersized for your pool. They recommend to do 50% the size of the pool. You would have to have an expert chime in on this. You can still do all the piping and just cut that in later...

New AGP Install (Hampshire, IL) Started April 2016 Sent from my SM-G920V using Tapatalk

Are toy going to hard pipe PVC? If so look at my build post, it's not that hard and I posted the parts list on there. Sent from my SM-G920V using Tapatalk

Looking good!! Hopefully you will be swimming soon! We were in the same boat with rain and delays. Then when the deck got framed we had a week and a half of covered pool and no way to get in... You guys will be enjoying soon! Sent from my SM-G920V using Tapatalk

Did work on the deck and around the pool and when the kids got home we all jumped in!! To hard to look at that nice TFP water and not swim! Sent from my SM-G920V using Tapatalk

Ouch!! That's one way to get some stairs.... Sent from my SM-G920V using Tapatalk