Recent content by ckwinters

  1. C

    URGENT Help needed! Please! Leak?!

    Been there, done that...we accidently siphoned off pool water by leaving the submersible pump in after unplugging it. Had the same oh-no moment of thinking it was a major leak!!
  2. C

    Pool Store & More inground pool wall kit with liner

    We did poolwarehouse with good results. If you search the forum for poolwarehouse or other keywords you'll find some good build threads.
  3. C

    No built in skimmer diverter. Any options?

    And now here is the pict!
  4. 20210523_140050_HDR(1).jpg

    20210523_140050_HDR(1).jpg

  5. C

    No built in skimmer diverter. Any options?

    Here's one I built last fall to keep at least one skimmer from clogging due to leaves in the fall and locust tree flowers in the spring. I put the lip around the bottom to capture degree when I'm left it out.
  6. C

    Help on how to prep for coping install around a steel panel pool

    We did pavers and did a single 8 gauge wire around the pool under the pavers attached at 4 points. Under the diving board and ladder concrete we do have rebar and mesh the copper wire is attached to.
  7. C

    Pool base - Minnesota pool install

    We did a concrete and sand mix. Had a local company deliver it and they dumped right into the pool to be spread. No regrets except wish it was spread out smoother. There was a storm rolling in so we were very rushed and it looks a bit like the surface of the moon when the lights are on.
  8. C

    New pool build June(started)

    We did pavers and are happy with our decision. It did take longer and we waited until the following spring to do them. They get hot but I don't like blinding lighter colors so it was a bit of a trade off. We also didn't think we could tackle that much concrete on our own. When we priced out...
  9. C

    New pool build June(started)

    That looks great! Good job and you moved much faster than my husband and I. It took us two months from breaking ground to dropping a hose in to fill the pool. Yes, I would add liquid chlorine and stir it with a brush to keep the water clear until your test kit arrives. If you got a robot...
  10. C

    New 20x41x30 L Vinyl Pool Going In Near Pittsburgh

    We have two of the same lights in our 16,42x26 and it is bright. The good part is if one goes out you still have one light working. We also did pool warehouse and fully DIY so kept it simple with no automation. I like our sand filter but haven't had to deep clean it yet so that may change our...
  11. 20200521_151108.jpg

    20200521_151108.jpg

  12. C

    New Build - DIY IGP in Minnesota

    We did a DIY from pool warehouse and here my two cents as a non professional. We didn't do main drains and haven't noticed the water temps being noticeably different. We do have aqua genie skimmer/returns which may be part of the reason. The only time a main drain would have been handy is...
  13. C

    DIY PA - Paver time is coming!

    I work in Harrisburg so very close neighbors! So you asked if we would do it again? I would do it ONCE but I would not be willing to put my family thru that twice :). It really did consume almost a year of our time with planning, building and cleanup. The pattern was go to work, get home...
  14. 20190626_143308_HDR_resized.jpg

    20190626_143308_HDR_resized.jpg

  15. C

    Bonding question - Upper and lower?

    When I say above ground I actually mean under pavers. It was the diving board, ladders, pump etc.