Recent content by boston62

I got it working. 1. first set add pool, total run time..ex 8am to 4pm with Filtratration at the slowest speed, the when adding to schedule pick vsp1 for pump, the High Speed....working good.. Thanks everyone.

well that didn't work, the only thing I can think of is the Iaqualink 2.0 antenna I added to my system, I had the 1.0 blue one that came with the unit, which the antenna broke off, so I replaced it with the new 2.0 antenna.I really don't think this would stop the schedule from running.

I changed them to the default labels, we'll see if the schedule runs...Thank you

when I add to the schedule I pick the VSP1 for the pump, I will change the labels, even though have it so you can customize the label. Thabks

Here

Thank you for that info...I have seen so many videos, but no help. The system is 14 years old, but runs with no problems until a week ago...I can change speeds manually, but in a schedule it will not start at time specified.

anyone know how to set a schedule to run my pump @ 1. Start 8:00 - 8:59 AM @ 3000 RPM 2. 9:00 AM - 4:00 PM @ 2000RPM' The problem it will not run in the Schedule, but i can hit the Pump Button and it runs at the correct speed for that time.. Zodiac is not much help...

It seams I am always chasing my PH & Alkalinity, is this do to my Salt Generator? Thanks

I put new ones on with all holes, but still hangs up, why do they make them so high, they can be flat... I'm sure they have them somewhere

thanks for the info, the covers were all the same, i ordered new ones from Amazon. Thank you...

I want to replace my covers with a more flatter cover, my pool has 2 on the bottom of main pool and 2 on attached spa, i removed the one from spa to look for manufacturing numbers, the drain from spay had SP 1048E, do you think the covers in the pool section would be the same? I didn't want to...

the wires connected to the green terminal bar, right side labeled low Voltage Heat on the Iaqualink. It looks like it was spliced in on the blue wire from temp switch, the old heat pump was a Jandy Aquacal 18 years old. The new heat pump is Ruud 140 Heat Pump sold by Recreation Warehouse...

I am replacing my old heat pump, and hooking up my Iaqualink to it. Here is where the old Iaqualink was connected. would i just hook the new heat pump in the same location, the round device with blue wire is that the temp switch? Thank you