O
Latest activity Postings Media About
-
-
Oogdento replied to the thread Compool valves not working properly.[EDIT] I should have prefaced this with "run this test to be sure your valves are good" what i usually do to test a valve is connect it...
-
Oogdento replied to the thread Intellitouch panel no leds lit but Reset button turns them on.Hey Blair it sounds like the indoor and outdoor mainboards are toast... I "think" I fixed your indoor for you once before... maybe a few...
-
Oogdento replied to the thread Intellicenter i5P died.
-
-
Oogdento replied to the thread Intellicenter i5P died.Hey @wgipe , I just looked at another dead i5p board and (so far) the bridge rectifier on the 18vac input is shorted (it's the one made...
-
Oogdento replied to the thread Intellicenter i5P died.agh, thanks for asking them about the separate boards... I was nervous the first time I pulled one apart, but if they just told folks...
-
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.yyyikes! i could see from the back side image that the transformer also got hot, but those photos didn't show those scorch marks...
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.Thanks James! that's much easier than flipping between both pages ;) So the burn corresponds to the green resistor hiding behind c4
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.The one I had had traces that had actually melted away... which yours does not have. But comparing the back side image to the top side...
-
Oogdento replied to the thread Intellicenter i5P died.I don't recall @ajw22 's board doing any weird like clicking relays or drawing too much current... so I don't think his relay drivers...
-
Oogdento replied to the thread Intellicenter i5P died.Bummer. Sorry to hear that yours croaked. Do you recall any storm events the day before it died? The faint clicking is...
-
-
Oogdento replied to the thread Pentair Mastertemp 400 Electrical Issues.hey guys I'm sorry but I don't have any experience with these heater boards (I don't have a heater). I have however seen a Fenwal board...
-
Oogdento reacted to Dan-H's post in the thread replacing easytouch 8 circuit board; a couple of questions with
Like.
Thanks @ogdento I stumbled across the actuator fix a couple of years ago. I had four pentair actuators fail and thankfully had not... -
Oogdento replied to the thread replacing easytouch 8 circuit board; a couple of questions.if the chips don't solve it, it may be worth looking at the microswitches inside the valve actuators... Valve Actuators - Further Reading
-
Oogdento reacted to geobrick's post in the thread How to perform firmware upgrade on Pentair* controllers with Like.
I just updated my EasyTouch to version 2.190 from 2.160. I didn't really need it, but I wanted to see if they fixed whatever the issue...
-
-
Loading…
-
Loading…
-
Loading…
