I just installed a Century Vgreen EVO Vaariable speed 1.5 pump to replace my 3/4hp single speed whisper flo. The new pump is specifically made a drop In replacement. I installed and wired per the user manual, particularly the low voltage two wire RS-485 from the pump to the Easy Touch. When I press the filter pump button on the Easy panel the pump lights up but doesn’t run. Pic below shows that the pump wiring (tagged with blue tape) is connected to load instead of line which may be wrong per a previous thread I saw. But I also see that the same load wiring has a jumper that goes to some kind of transformer which concerns me. Should that jumper be moved to line as well? Software version for Easy Touch is 2.09.