I am running a new Jandy EPump variable speed system. Installed lass than a year ago.
Running fine this morning, I shut it down to clean the salt cell. Once done, assembled the system but I think maybe the contacts on the salt cell were still wet/damp when I connected it all up because now, even when I select Pump on the app or circuit board, it beeps and I hear the click in the circuit board but the pump won't run. Dried off the posts but still nothing. The app and circuit board show it as running.
Did I short something out? Need to wait longer and let it dry in the sun? (In Texas so it will dry quickly)
Any suggestions? And again, thank y'all so much. This place is awesome, I wish I had the knowledge to help others like the help I have received here.
Running fine this morning, I shut it down to clean the salt cell. Once done, assembled the system but I think maybe the contacts on the salt cell were still wet/damp when I connected it all up because now, even when I select Pump on the app or circuit board, it beeps and I hear the click in the circuit board but the pump won't run. Dried off the posts but still nothing. The app and circuit board show it as running.
Did I short something out? Need to wait longer and let it dry in the sun? (In Texas so it will dry quickly)
Any suggestions? And again, thank y'all so much. This place is awesome, I wish I had the knowledge to help others like the help I have received here.
