Actuator Connector type

[Katodude]

I want to start the wiring for the pool controller actuators. I am trying to find the specs for the 3 pin connector. A search over here resulted in some people thinking they were a J.S.T. HX type. I found the Jandy 2711 connector but could not get the specs. I was hoping to buy some with the pig tails already connected. Anyone know if they are 2.54mm or 3mm?

 

[Katodude]

Well I kept searching, and I think they are the JST XH connectors. I ordered some and will report back if they are correct.

 

[Katodude]

Well in case anyone cares.

The correct size is the JST HX connector which is a 2.54mm connector.

I now have 20 of them from Amazon.

 

[PoolGate]

Are you building your own controller?

 

[Katodude]

Yes I am. Here is my thread on that. I am hoping to post an update either today or this weekend.

Yet another DIY pool controller thread

So after reading a bunch of these threads and threatening to do something like this I started to pull the trigger. Thanks to segalion, jonpcar who have provided very interesting reading, and most of all cmc0619 who ideas I primarily "borrowed" 1 Raspberry Pi 3b 1 Sequentmicrosystems MegaIO...

www.troublefreepool.com