So we had our pool indoctrination yesterday, and the start up of our Nature 2 Fusion Soft system. We did not install the start up mineral cartridge that they give you, based on the discussions on TFP about the minerals. Salinity was reading .5 with an error code of 144 (low salinity) before anything was done. 8 bags of salt were added to the pool and immediately the salinity levels started to rise. The pool company did there little stick test which showed low chlorine, high PH, low hardness immediately after adding the salt. They advised us to wait a few hours and then test again.
I waited over night, this morning the SWG was reading salinity of 3.0 with no error codes. The pool company provided test sticks still showed low chlorine, high PH, low hardness. Did the chlorine test with the TFP-100 kit and got no color change what so ever, leading me to believe there is no chlorine being produced. So how can the SWG read 3.0 and my test show none?
Pool water is cloudy.
Thoughts? Suggestions?
I waited over night, this morning the SWG was reading salinity of 3.0 with no error codes. The pool company provided test sticks still showed low chlorine, high PH, low hardness. Did the chlorine test with the TFP-100 kit and got no color change what so ever, leading me to believe there is no chlorine being produced. So how can the SWG read 3.0 and my test show none?
Pool water is cloudy.
Thoughts? Suggestions?