Hello all,
I have an easytouch controller with an intelliflo vs pump. I keep the pump on for 16 hours a day at 1000 rpm, and it takes about 3000 rpm for a minute or two to get all the bubbles out once the solar valve opens. then, I can slow it down to 2000 rpm and it keeps going with no problem. If I just ramp it up from 1000 to 2000 when the solar opens, it keeps blowing bubbles for a long time, which tells me the vacuum relief valve on the roof isn't closing.
Solution: when the solar valve opens, run at 3000 rpm for 1 minute, then at 2000 rpm until the valve closes.
How do you do this in easytouch? it doesn't seem to have it built in. I can create a feature, call it "solar priming", define it as 3000 rpm, and put it on an egg timer of 1 minutes But how do I tell the easytouch to run this feature when the solar valve opens?
Thanks!
I have an easytouch controller with an intelliflo vs pump. I keep the pump on for 16 hours a day at 1000 rpm, and it takes about 3000 rpm for a minute or two to get all the bubbles out once the solar valve opens. then, I can slow it down to 2000 rpm and it keeps going with no problem. If I just ramp it up from 1000 to 2000 when the solar opens, it keeps blowing bubbles for a long time, which tells me the vacuum relief valve on the roof isn't closing.
Solution: when the solar valve opens, run at 3000 rpm for 1 minute, then at 2000 rpm until the valve closes.
How do you do this in easytouch? it doesn't seem to have it built in. I can create a feature, call it "solar priming", define it as 3000 rpm, and put it on an egg timer of 1 minutes But how do I tell the easytouch to run this feature when the solar valve opens?
Thanks!