I have Ecostar pump (bought in March 2012) and am gearing up for Omnilogic self-install.
I have 2 questions:
1. How do I find out if my pump's firmware needs to be updated and how do I go about it?
2. Looking closely at the Omnilogic as well as Ecostar installation docs, I couldn't figure out where the 2 wire combus from Ecostar should be plugged in into Omnilogic board. Looks like Omnilogic has a low speed bus plugs, and what looks like a 4-pin terminal just below them:
https://www.mypoolyard.com/images_pdf/omnilogic-hlbase-install.pdf page 10 (actual page 14). Can you provide some light on this?
Thanks a lot!
V.B.
I have 2 questions:
1. How do I find out if my pump's firmware needs to be updated and how do I go about it?
2. Looking closely at the Omnilogic as well as Ecostar installation docs, I couldn't figure out where the 2 wire combus from Ecostar should be plugged in into Omnilogic board. Looks like Omnilogic has a low speed bus plugs, and what looks like a 4-pin terminal just below them:
https://www.mypoolyard.com/images_pdf/omnilogic-hlbase-install.pdf page 10 (actual page 14). Can you provide some light on this?
Thanks a lot!
V.B.
The ecostar plugs in the low speed bus and it should output a Hayward Unique Identifier (HUA). In the omnilogic setup, you select the ecostar from a list of equipment with HUA's. On mine, the list is empty. Everything else has been easy to setup and configure, but the pump has me stumped. Last night I turned the pool lights on from someone else's house using my iPhone. It also sends email notifications when errors occur ( Low salt, lost commo, etc). I have a rep, but he is off till Monday.