I just installed the autopilot DIG 220 / SC60 yesterday. I set it up for 50% level 2 to start and running the pump from 8 am to 8 pm (using the autopilot timer program 1- deleted program 2 time). It ran for about 4 hours and shut off at 8 and it raised the CL level to 2.5 and water temp was 90.
This morning I went out and looked at it before going to work -- the output level was down to 18% (it was not running - before 8 am). I increased the output - but it would only go up to 31% nothing higher. I forced the pump on manual override.
So my question -- why did the output level drop when the pump was not running Why would it only go to 31%. Am I missing something -- or any explanation is appreciated - do I need to do anything.
Also -- is there a way to 'reset' the autopilot calibration on the salt level. Meaning - if I accidently changed the salt calibration (to something wrong)-- is there a way to reset it to factory default so I know what it is reading correct - or if I need to calibrate it to my salt reading.
This morning I went out and looked at it before going to work -- the output level was down to 18% (it was not running - before 8 am). I increased the output - but it would only go up to 31% nothing higher. I forced the pump on manual override.
So my question -- why did the output level drop when the pump was not running Why would it only go to 31%. Am I missing something -- or any explanation is appreciated - do I need to do anything.
Also -- is there a way to 'reset' the autopilot calibration on the salt level. Meaning - if I accidently changed the salt calibration (to something wrong)-- is there a way to reset it to factory default so I know what it is reading correct - or if I need to calibrate it to my salt reading.