I have had the board/card replaced by a authorized service rep 3 times in the past 2 mounths. I am now on the 4th board/card that I installed myself, service rep mailed board/card along with a new cable. This was installed yesterday. I purchased the Autopilot Digital with sc 60 cell software verison 4.2. The new board/card is an upgrade software verison 4.4. The question I have is
1. When I powered the Autopilot on after installing the new board/card the display flashes on/off in an 3 to 5 sec cycles is this normal?
I was able to setup the system just fine display does not flash when in setup mode.
2. Also today when I got home from work I check the system there was no display I touched one of the display buttons and it came on is this normal?
3. I am also unable to calibrate the salt level. When I try the display reads "not ready yet".
4. I did talk with the service rep today and was told that the card maybe in Demo mode. So I disable this. I still can't calibrate the salt content.
Any help with this would be great.
Thanks
1. When I powered the Autopilot on after installing the new board/card the display flashes on/off in an 3 to 5 sec cycles is this normal?
I was able to setup the system just fine display does not flash when in setup mode.
2. Also today when I got home from work I check the system there was no display I touched one of the display buttons and it came on is this normal?
3. I am also unable to calibrate the salt level. When I try the display reads "not ready yet".
4. I did talk with the service rep today and was told that the card maybe in Demo mode. So I disable this. I still can't calibrate the salt content.
Any help with this would be great.
Thanks