Hi All. I have an intelliflo VS pump. I also have iAqualink pool controls. When the pump turns on, it first "primes" then it goes to whatever setting I have it on. I can set the RPMS for when it primes...right now it's set at 2350 rpms for priming. Is this good or can i set it lower?
Basically i have it set on a maintain heat setting, so every 3 hrs it turns on to test the temp of the water. So it primes at 2350 then samples the water at 1150. If it needs heat, it goes back to 2350 and either the solar heater kicks on or the gas (depending).
So id rather have the priming speed lower if possible. But im not sure if that is ok or not?
Basically i have it set on a maintain heat setting, so every 3 hrs it turns on to test the temp of the water. So it primes at 2350 then samples the water at 1150. If it needs heat, it goes back to 2350 and either the solar heater kicks on or the gas (depending).
So id rather have the priming speed lower if possible. But im not sure if that is ok or not?