Hello everyone,
My current pump which is a Jandy PlusHP 2.5HP (PHPM2.5) is going bye bye, and based on some feedback from my previous thread (http://www.troublefreepool.com/thre...-(previously-neglected-pool)-piping-question), I decided to go with the Pentair SuperFlo 1HP 2 speed.
I am good at connecting the pipe, unions, and everything plumbing, but the electrical is a little trickier for me, and I would like some help figuring that out.
The wiring diagram on the label is unreadable, so I am not really sure how to wire this new pump.
In this Google album (maybe because I'm a new member, I can't upload images or they have to be really small), you can see images of the Label on the Pump, the wiring connectors and toggle switch, and the wiring on the old pump:
https://plus.google.com/photos/1007...ms/6063761556065379697?authkey=CNmxne2opumiDA
On the old pump wiring, I have two red wires coming from the timer, plus a green/brow (it's green then there's an extension mid way which becomes brown on the pump - as you can see on the last image)
On the new pump, there are 3 connectors and they are labeled: 1 (empty), 2 (yellow wire connecting to the toggle switch), 3 or 4 (white wire connecting to the switch). In addition, as you can see on the second image, the toggle switch (which is hanging on the left side of the image) has a black wire that is capped, where should that one be connected to?
I would really appreciate If someone could help me figure out how to connect these wires.
Thanks,
Alex
My current pump which is a Jandy PlusHP 2.5HP (PHPM2.5) is going bye bye, and based on some feedback from my previous thread (http://www.troublefreepool.com/thre...-(previously-neglected-pool)-piping-question), I decided to go with the Pentair SuperFlo 1HP 2 speed.
I am good at connecting the pipe, unions, and everything plumbing, but the electrical is a little trickier for me, and I would like some help figuring that out.
The wiring diagram on the label is unreadable, so I am not really sure how to wire this new pump.
In this Google album (maybe because I'm a new member, I can't upload images or they have to be really small), you can see images of the Label on the Pump, the wiring connectors and toggle switch, and the wiring on the old pump:
https://plus.google.com/photos/1007...ms/6063761556065379697?authkey=CNmxne2opumiDA
On the old pump wiring, I have two red wires coming from the timer, plus a green/brow (it's green then there's an extension mid way which becomes brown on the pump - as you can see on the last image)
On the new pump, there are 3 connectors and they are labeled: 1 (empty), 2 (yellow wire connecting to the toggle switch), 3 or 4 (white wire connecting to the switch). In addition, as you can see on the second image, the toggle switch (which is hanging on the left side of the image) has a black wire that is capped, where should that one be connected to?
I would really appreciate If someone could help me figure out how to connect these wires.
Thanks,
Alex