- Jan 7, 2008
- 173
So our Autopilot Dig SC60 is finally up and operating. We were not anticipating when it would be fixed, so I had loaded up on the chlorine levels b/c we had some organic material from the paver sand in our pool. The foaming of the water since I added more CL last night has diminished alot.
This morning the chlorine levels were at 9.5ppm. I turned the purifier off for now b/c I was reading in the manual that excessive CL levels can be corrosive. Should I wait until the CL levels drop to about 4ppm b/f turning on the purifier on the SWG?
My other readings this morning were
TC 9.5
pH 7.8 (going out to pool to add some acid right now)
TA 90
CYA 40 (added one container this morning to add another 15ppm)
CH 110
Salt 2800-3200ppm
This morning the chlorine levels were at 9.5ppm. I turned the purifier off for now b/c I was reading in the manual that excessive CL levels can be corrosive. Should I wait until the CL levels drop to about 4ppm b/f turning on the purifier on the SWG?
My other readings this morning were
TC 9.5
pH 7.8 (going out to pool to add some acid right now)
TA 90
CYA 40 (added one container this morning to add another 15ppm)
CH 110
Salt 2800-3200ppm