Split by moderator from HERE. Please start a new thread for your own questions. Thanks, jblizzle
Anybody know where to pickup the Gefeg brand motors for the Dolphin Diagnostic? I, too, had the desiccant bad rupture, although it didn't seem to short out the board since it's sillica(?). The impeller motor seems ok, although the rear bearing is making sounds and the rotor is pretty worn. I will try to oil it. haha The track motor was running, amazingly, since one brush had been chewed up and was ripped from the spring contact. The rotor is also very worm. The electronics seem fine. I might call Gefeg and see if I can get some new brushes - doubt it. Unfortunately, the rotor commutator contacts are really worn, in general. Check them out:
Anybody know where to pickup the Gefeg brand motors for the Dolphin Diagnostic? I, too, had the desiccant bad rupture, although it didn't seem to short out the board since it's sillica(?). The impeller motor seems ok, although the rear bearing is making sounds and the rotor is pretty worn. I will try to oil it. haha The track motor was running, amazingly, since one brush had been chewed up and was ripped from the spring contact. The rotor is also very worm. The electronics seem fine. I might call Gefeg and see if I can get some new brushes - doubt it. Unfortunately, the rotor commutator contacts are really worn, in general. Check them out: