Has anyone installed a 1/2" line to their liquidator?
Reason I'm asking is because I have a variable speed pump and a bypass valve to eliminate the heater from the flow path. With the 3/8" line to the Liquidator and the bypass open eliminating the back pressure created by the heater, the Liquidator flow meter shows too little flow. I have to close off the bypass to create enough back pressure to flow through the liquidator.
With the bypass open, there is a significant increase in flow without any increase in pump speed.
I was thinking if the line ID was increased from 3/8" to 1/2" it might provide enough increased flow to the Liquidator so the bypass could remain open.
The other option is to install a chlorine pump system from the chlorinator.
Any thoughts? Thanks!
Reason I'm asking is because I have a variable speed pump and a bypass valve to eliminate the heater from the flow path. With the 3/8" line to the Liquidator and the bypass open eliminating the back pressure created by the heater, the Liquidator flow meter shows too little flow. I have to close off the bypass to create enough back pressure to flow through the liquidator.
With the bypass open, there is a significant increase in flow without any increase in pump speed.
I was thinking if the line ID was increased from 3/8" to 1/2" it might provide enough increased flow to the Liquidator so the bypass could remain open.
The other option is to install a chlorine pump system from the chlorinator.
Any thoughts? Thanks!