I installed a new Hayward SwimPure Pluse SWG several days ago. I added the required salt three days ago then ran the pump for 24 hours as directed (3000 ppm per numerous dip stick tests). I held off turning on the unit because my FC was very high (a result of following pool store guidance that I have since stopped). About five hours ago I switched the unit on (at 50%) and plan on running the pump for 24 hours (as directed) before I accept the displayed salt value as accurate. My issue is that both the "Check Salt" AND the "Inspect Cell" lights are flashing. I fully expected the salt light because the directions indicated the 24 hour run was required for an accurate value but the Inspect Cell is causing concern. I reconfirmed that I selected the correct cell type in the configuration and held the diagnostic button to reset the inspect cell indication only to find it flashing again a short time later. Is this a normal finding during start up or do I have a problem with my new equipment? Any insight is appreciated.
Last edited: