My Fiberglas pool had problems from the beginning with the white wax coating (siren)through the gel coat after water was applied- defect in manufacturing. We were finally
able to scrap the wax coating off and I have my blue pool back. PROBLEM- on the attached pictures, the pieces that went through filter keep coming back
through the Jets when the pump starts at returns. I have continued to vacuum it to waste and it still comes back as shown in photos. Finally last week, I went ahead and replaced the Sand knowing it would not come back. Now, it’s still coming back in through the jets. Is this in the pipes somewhere
and will be eventually go away if I continue to pick up and send to waste? can post any pictures for some reason, says I am over the limit.
able to scrap the wax coating off and I have my blue pool back. PROBLEM- on the attached pictures, the pieces that went through filter keep coming back
through the Jets when the pump starts at returns. I have continued to vacuum it to waste and it still comes back as shown in photos. Finally last week, I went ahead and replaced the Sand knowing it would not come back. Now, it’s still coming back in through the jets. Is this in the pipes somewhere
and will be eventually go away if I continue to pick up and send to waste? can post any pictures for some reason, says I am over the limit.
