Our 28 ft round above ground pool was just set up. We have had 3 loads of water trucked in, about 18,000 gallons (topping up the rest with our own well water, it is almost there). The water comes from a municipal source (Gettysburg water, if anyone likes American History ).
Here are my results from my TF-100 kit so far:
FC: 0
CC: 0.5 ppm ((???) on this - it turned a slight pink)
PH: 7.2
TA: 60
CH: 100
CYA: 0
Would these results make sense for a municipal water source, or have I made an error somewhere?
Pool builders put nothing into the pool. I have been instructed to take my sample to the pool store tomorrow morning, where they will then test it then give me instructions and the chemicals that come with the pool.
I'm planning on getting my chemicals (you know, "free" ) and then doing the TFP calculations and working with the chlorine, CYA, etc from there. Think that will work? Advice, suggestions, etc?
We will take all the help we can get! Much thanks!!!
Here are my results from my TF-100 kit so far:
FC: 0
CC: 0.5 ppm ((???) on this - it turned a slight pink)
PH: 7.2
TA: 60
CH: 100
CYA: 0
Would these results make sense for a municipal water source, or have I made an error somewhere?
Pool builders put nothing into the pool. I have been instructed to take my sample to the pool store tomorrow morning, where they will then test it then give me instructions and the chemicals that come with the pool.
I'm planning on getting my chemicals (you know, "free" ) and then doing the TFP calculations and working with the chlorine, CYA, etc from there. Think that will work? Advice, suggestions, etc?
We will take all the help we can get! Much thanks!!!