Ok guys, I ordered the Taylor K2006 test kit and just did my first full tests. I'm a bit confused on the FC vs CC but maybe it's right idk. The pool is a Vinyl lined 16 x 32. Sand filter. I use Trichloro Tablets for chlorination.
FC: 7.4 ppm
CC: .4 ppm???
PH: 7.0
TA: 80 ppm
CH: 140 ppm
CYA: 100+ Water level was FAR from 100 on the black dot test
The CC reads .4 ppm but the FC is 7.4. I knew it was high as I'm coming down from SLAMing the pool a few weeks ago.
Obviously the CYA is VERY HIGH and needs to be brought down.
The PH is getting back Low as well and I need to add Base to bring it up.
Is there any instructions or advise you can give me based on my results? If a test result sounds off, i will test again. Thanks in advances.
FC: 7.4 ppm
CC: .4 ppm???
PH: 7.0
TA: 80 ppm
CH: 140 ppm
CYA: 100+ Water level was FAR from 100 on the black dot test
The CC reads .4 ppm but the FC is 7.4. I knew it was high as I'm coming down from SLAMing the pool a few weeks ago.
Obviously the CYA is VERY HIGH and needs to be brought down.
The PH is getting back Low as well and I need to add Base to bring it up.
Is there any instructions or advise you can give me based on my results? If a test result sounds off, i will test again. Thanks in advances.