Hello, I am a new pool owner. My pool is 24x12 in ground indoor and is 10800 gallons. It has a vinyl liner and the pool is heated.
I have a sand filter and a Jandy AquaPure Ei Series Salt Generator. I just filled the pool with new water. Added bleach to shock the water and get the chlorine level and Ph up to normal. Added 2.5 lbs of CYA to the skimmer in a sock.
When reading over the SWG manual, it states...
"When setting the chlorine output level you must consider the size of the pool, the amount of use the pool will be receiving
and how hot the weather is. All these factors weigh greatly on the level of output needed."
So my question is, how do I figure this out? What should I set the SWG chlorine output at? The pool will be heated to around 77-79 Degrees. I have a timer hooked up to the filter so I can set the timer to run at any given time during the day.
Please help with this?
Thanks,
Bruce
I have a sand filter and a Jandy AquaPure Ei Series Salt Generator. I just filled the pool with new water. Added bleach to shock the water and get the chlorine level and Ph up to normal. Added 2.5 lbs of CYA to the skimmer in a sock.
When reading over the SWG manual, it states...
"When setting the chlorine output level you must consider the size of the pool, the amount of use the pool will be receiving
and how hot the weather is. All these factors weigh greatly on the level of output needed."
So my question is, how do I figure this out? What should I set the SWG chlorine output at? The pool will be heated to around 77-79 Degrees. I have a timer hooked up to the filter so I can set the timer to run at any given time during the day.
Please help with this?
Thanks,
Bruce