Howdy!
After I had issues with my pump rapidly turning on and off I tried replacing the relay only to have it happen again when the temps got close to freezing again. So I figured the board may be bad and got a new iAqualink system complete with new PCB. It works great and the rapid firing issues have gone away. My questions now are:
- can I hook up my old button controller I used with the old system? It would be nice to have an alternative if wifi goes out.
- is the PCB the real "brains" to the system or should I worry that maybe it was the controller causing the pump to rapidly fire?
- if I can use the old controller do I set the jumper for multiple controllers and set it to first or second controller?
The iAqualink says the interface is "aqualink touch" and the model is "RS-4 combo"
The aqualink is "REV S"
Thanks for any all info/advice!
After I had issues with my pump rapidly turning on and off I tried replacing the relay only to have it happen again when the temps got close to freezing again. So I figured the board may be bad and got a new iAqualink system complete with new PCB. It works great and the rapid firing issues have gone away. My questions now are:
- can I hook up my old button controller I used with the old system? It would be nice to have an alternative if wifi goes out.
- is the PCB the real "brains" to the system or should I worry that maybe it was the controller causing the pump to rapidly fire?
- if I can use the old controller do I set the jumper for multiple controllers and set it to first or second controller?
The iAqualink says the interface is "aqualink touch" and the model is "RS-4 combo"
The aqualink is "REV S"
Thanks for any all info/advice!