Hello all,
I am new here and have just had a 38' x 18 oval in-ground liner pool installed.
My concern is the finish on the cement pool bottom and what is acceptable as far as smoothness or deviation of high low areas. Overall the bottom looks fair IMO, however when you turn the pool light on it amplifies the waviness.
I have had two pools in the past, however I have never had a pool light in either of them so I do not know what to expect as far as a acceptable pool floor finish. Can someone shed some light on what is reasonable and what is getting to carried away with my expectations.
Below is a link to my pool photo build. Thoughts and comments are welcome.
http://s29.photobucket.com/user/cudavic ... t=2&page=1
Here is another link for the liner as this is where my concerns was with the pool bottom surface finish.
Some of the photos are before I cleaned the leaves out so forgive me.
http://s29.photobucket.com/user/cuda...?sort=3&page=1
As you can see there is one wrinkle in the liner that I can hopefully get out in the spring by lowering the water level and using a couple toilet plungers to work it to the outer wall panel.
This second set shows the stairs.
http://s29.photobucket.com/user/cuda...?sort=3&page=1
I am not sure what to think as the stairs have to land on top of the metal wall panel so you cannot make them any lower than they were installed. Is it possible that they installed the wrong style stairs? It almost looks like these are supposed to be used with a finished concrete coping where the liner bead is instead of the white bull nose coping.
Finally here are a few of the finished pool and spa photos.
http://s29.photobucket.com/user/cuda...?sort=3&page=1
Thanks in advance, Victor from N.E. Georgia
I am new here and have just had a 38' x 18 oval in-ground liner pool installed.
My concern is the finish on the cement pool bottom and what is acceptable as far as smoothness or deviation of high low areas. Overall the bottom looks fair IMO, however when you turn the pool light on it amplifies the waviness.
I have had two pools in the past, however I have never had a pool light in either of them so I do not know what to expect as far as a acceptable pool floor finish. Can someone shed some light on what is reasonable and what is getting to carried away with my expectations.
Below is a link to my pool photo build. Thoughts and comments are welcome.
http://s29.photobucket.com/user/cudavic ... t=2&page=1
Here is another link for the liner as this is where my concerns was with the pool bottom surface finish.
Some of the photos are before I cleaned the leaves out so forgive me.
http://s29.photobucket.com/user/cuda...?sort=3&page=1
As you can see there is one wrinkle in the liner that I can hopefully get out in the spring by lowering the water level and using a couple toilet plungers to work it to the outer wall panel.
This second set shows the stairs.
http://s29.photobucket.com/user/cuda...?sort=3&page=1
I am not sure what to think as the stairs have to land on top of the metal wall panel so you cannot make them any lower than they were installed. Is it possible that they installed the wrong style stairs? It almost looks like these are supposed to be used with a finished concrete coping where the liner bead is instead of the white bull nose coping.
Finally here are a few of the finished pool and spa photos.
http://s29.photobucket.com/user/cuda...?sort=3&page=1
Thanks in advance, Victor from N.E. Georgia