Good evening,
Yet again tonight I had my spa heat to the preset temp of 99 degrees and after it does heat up which takes about 45 minutes, the motor turns off, the red light of the aqualink panel turns green (versus red while it is heating). To this point I believe this is all normal.
The problem is that it just never turns back on, and obviously not maintaining the temp setting.
The light on the panel stays green and the display says spa heat enabled. But that's it, it just does not turn back on by itself.
However, I can scroll thru the controls to the one touch option and choose spa mode and it in fact will fire the heater and motor back up and will heat up to the preset temp, obviously taking a much shorter time frame cause it's fairly warm already, but the same thing happens again in that it will not cycle on and off to maintain the preset temp.
Help, thoughts?
Thank you, Dave
Yet again tonight I had my spa heat to the preset temp of 99 degrees and after it does heat up which takes about 45 minutes, the motor turns off, the red light of the aqualink panel turns green (versus red while it is heating). To this point I believe this is all normal.
The problem is that it just never turns back on, and obviously not maintaining the temp setting.
The light on the panel stays green and the display says spa heat enabled. But that's it, it just does not turn back on by itself.
However, I can scroll thru the controls to the one touch option and choose spa mode and it in fact will fire the heater and motor back up and will heat up to the preset temp, obviously taking a much shorter time frame cause it's fairly warm already, but the same thing happens again in that it will not cycle on and off to maintain the preset temp.
Help, thoughts?
Thank you, Dave