I am installing a new pump and have to run new wire for it. The pump is a two speed 230v motor.
According to the diagram I only hook up two wires. One is the black which goes to the switch,and the other is the common, which connects to the common terminal. What do I do with the third wire, knowing that the bare wire connects to ground.
I read through a lot of the previous topics and remember one topic where it said to just cap the white wire. If this is actually true, can I just run 10/2. If that is correct then how do I wire it to the circuit?
I will post pics in a bit. I only have internet on my phone so it takes a bit to figure it all out.
According to the diagram I only hook up two wires. One is the black which goes to the switch,and the other is the common, which connects to the common terminal. What do I do with the third wire, knowing that the bare wire connects to ground.
I read through a lot of the previous topics and remember one topic where it said to just cap the white wire. If this is actually true, can I just run 10/2. If that is correct then how do I wire it to the circuit?
I will post pics in a bit. I only have internet on my phone so it takes a bit to figure it all out.