Last week I cam back home from working abroad and I noticed the lights on the SWG were blinking, High salt, but also the PWR light was reading Red. I opened the unit and realized it needed to be cleaned. I did and it looked fine. When I plugged it back in and had it up and running, the PWR light was still red. The CELL light was blinking green and the high salt light was blinking. I called Pentair and the rep wanted to know what I was reading on the panel. No communication. After opening the Easy Touch, I discovered whoever installed the pool didn't bother to connect the Intellichlor board and the easy touch panel. After a little help, I made a connection wire and the two units are communicating.
This is what the Intellichlor is listing under diagnostics:
CHLORINATOR INFO
SALT: 5150 ppm
STATUS
[CHECK FLOW/PCB}
I'm going to take a sample in tomorrow to be tested, but until then....anyone have any ideas what's wrong?
Thanks.
This is what the Intellichlor is listing under diagnostics:
CHLORINATOR INFO
SALT: 5150 ppm
STATUS
[CHECK FLOW/PCB}
I'm going to take a sample in tomorrow to be tested, but until then....anyone have any ideas what's wrong?
Thanks.