I just installed a conversion kit (3port cell, power cable, tri-sensor) and chose to install as intended with the tri-sensor in the third port. I replumbed my system removing the old sensor/T config.
Everything was going as planned until i was ready to plug in the tri-sensor and realized that I had been sent the "daughter" card but did not receive any instructions of when to use as well as jumper and calibration instructions. I have since located the instructions but prior to that had tried all configurations...meaning I installed 1) with the daughter card - jumper on ; 2) with daughter card - jumper off; 3) without the daughter card. In all cases the result was that the system came on in "Cell Reversing" mode, just shortly after the Service light and service codes came on: 145, 172, 181. The salinity level was not high prior to installing the new kit and was verified by a local pool company.
Does anyone have any experience with this issue. My system did not have these codes prior to installing this kit. I installed because one the the 3 pins on my old 2-port cell corroded off and the system stopped producing Chlorine.
I would really appreciate help with this issue....I already spend $500 on the conversion kit....I really am committed to making this Jandy equipment work at this point.
Everything was going as planned until i was ready to plug in the tri-sensor and realized that I had been sent the "daughter" card but did not receive any instructions of when to use as well as jumper and calibration instructions. I have since located the instructions but prior to that had tried all configurations...meaning I installed 1) with the daughter card - jumper on ; 2) with daughter card - jumper off; 3) without the daughter card. In all cases the result was that the system came on in "Cell Reversing" mode, just shortly after the Service light and service codes came on: 145, 172, 181. The salinity level was not high prior to installing the new kit and was verified by a local pool company.
Does anyone have any experience with this issue. My system did not have these codes prior to installing this kit. I installed because one the the 3 pins on my old 2-port cell corroded off and the system stopped producing Chlorine.
I would really appreciate help with this issue....I already spend $500 on the conversion kit....I really am committed to making this Jandy equipment work at this point.