Hi all.
I have just converted over to a robotic system, leaving my pressure-side unit at this point an antiquated .
I am reworking the remainder of the pad this weekend, and will be converting the rest over to 2" (including the section that "T's" off the return line and goes to the pump supplying the pressure inlet).
The question I have is whether or not I can just convert the pressure inlet into a standard return, or what I should do with it, knowing that I will no longer be using the pressure pump. I would ultimately like to remove the pump from the pad altogether.
Thanks for any advice on this!
I have just converted over to a robotic system, leaving my pressure-side unit at this point an antiquated .
I am reworking the remainder of the pad this weekend, and will be converting the rest over to 2" (including the section that "T's" off the return line and goes to the pump supplying the pressure inlet).
The question I have is whether or not I can just convert the pressure inlet into a standard return, or what I should do with it, knowing that I will no longer be using the pressure pump. I would ultimately like to remove the pump from the pad altogether.
Thanks for any advice on this!