Hello,
First post here.
I've recently taken over the operation of an outdoor, in-ground pool with 2 above ground pumps. These pumps are above the water level by a good 3 feet when the pool is full. I operated the pool a bit last summer, and when the pumps were already holding prime, they started back up relatively easily.
I'm starting up the pool for the summer this week, so I need to figure out the initial prime. Any tricks of the trade for priming this kind of situation?
First post here.
I've recently taken over the operation of an outdoor, in-ground pool with 2 above ground pumps. These pumps are above the water level by a good 3 feet when the pool is full. I operated the pool a bit last summer, and when the pumps were already holding prime, they started back up relatively easily.
I'm starting up the pool for the summer this week, so I need to figure out the initial prime. Any tricks of the trade for priming this kind of situation?