This my first post.
I am getting conflicting results and don't know which ones to believe.
I don't know how to rectify the situation.
I have an Aqua Rite Electronic Chlorine Generator.
At the end of last season, I found that my generator was displaying salt levels much lower than I was seeing with pool samples taken to the pool store.
Salt levels we at or slightly below the minimum value of 2700.
I thought that this indicated that my T-9 cell was going bad.
This season I installed an new aftermarket Compupool GRC/25GH.
I reset the controller for a T-15 cell.
My Generator currently indicates the following
2500 Instantaneous Salinity
Temp 64F
Cell voltage 26.8-27
Current 4.72 - 4.83
Desired output - now 50%
AL-0, revision 1.5 t-15 cell
Pool sample were as follows
Salt 3200
Chlorine was 6.6
PH 7.4
Total Alk 61
Cyanuric acid 39
Hardness 290
I have a 23000 gallon IG pool with a 1 HP two speed Pac-Fab Challenger pump with 250 lb sand filter.
How should I resolve the issue with the Salt Generator or my cell?
Thanks.
I am getting conflicting results and don't know which ones to believe.
I don't know how to rectify the situation.
I have an Aqua Rite Electronic Chlorine Generator.
At the end of last season, I found that my generator was displaying salt levels much lower than I was seeing with pool samples taken to the pool store.
Salt levels we at or slightly below the minimum value of 2700.
I thought that this indicated that my T-9 cell was going bad.
This season I installed an new aftermarket Compupool GRC/25GH.
I reset the controller for a T-15 cell.
My Generator currently indicates the following
2500 Instantaneous Salinity
Temp 64F
Cell voltage 26.8-27
Current 4.72 - 4.83
Desired output - now 50%
AL-0, revision 1.5 t-15 cell
Pool sample were as follows
Salt 3200
Chlorine was 6.6
PH 7.4
Total Alk 61
Cyanuric acid 39
Hardness 290
I have a 23000 gallon IG pool with a 1 HP two speed Pac-Fab Challenger pump with 250 lb sand filter.
How should I resolve the issue with the Salt Generator or my cell?
Thanks.