Hi Guys,
So I'm installing a SWG (Jandy Aquapure eI Plug-In model) and one of the main reasons for choosing this was easy install and price. After receiving the SWG, I discovered I need a min of 2 1/2 ft of return line and 10 inches on each end from elbows and such (http://www.zodiacpoolsystems.com/~/medi ... 35900.ashx). My problem is that I only have 18 inches from filter to valve and I can't figure out a way to re-pipe without it looking unprofessional. I could return it and get the hardwired version which doesn't require that much pipe and it would be very easy to install, but this model was on clearance for $550 and the hard-wired version is $980. Any ideas?
Thanks,
David
http://www.lifelatelee.com/poolimages/poolequip.jpg
So I'm installing a SWG (Jandy Aquapure eI Plug-In model) and one of the main reasons for choosing this was easy install and price. After receiving the SWG, I discovered I need a min of 2 1/2 ft of return line and 10 inches on each end from elbows and such (http://www.zodiacpoolsystems.com/~/medi ... 35900.ashx). My problem is that I only have 18 inches from filter to valve and I can't figure out a way to re-pipe without it looking unprofessional. I could return it and get the hardwired version which doesn't require that much pipe and it would be very easy to install, but this model was on clearance for $550 and the hard-wired version is $980. Any ideas?
Thanks,
David
http://www.lifelatelee.com/poolimages/poolequip.jpg