Hello, and first thanks for the help.
I bought a new Hayward Ecostar Variable speed pump, installed it this morning, turned on the breaker the panel lit up as it should, gave me all the default info, I went through setup no problem, it turned on the pump ran, i cycled from speed 1 to 4 giving a minute at each speed, and checking psi on filter, and visually looking to see if water was successfully overflowing from spa back into pool as it would with my single speed pump.
Turned it off, came inside checked this website for tips on how to determine which speed to run at and how long etc.
went out side pressed speed 1 and it failed to start, pump basket is full of water, pump was already primed, it had worked.
the display says Drive Error, Pump has stalled.
I tried a few times, killed breaker waited 10 minutes powered up again and tried again, same result.
is my new pump defective??
any help on anything i should do besides yank it out take it back to leslies and demand a new one.
Thanks
I bought a new Hayward Ecostar Variable speed pump, installed it this morning, turned on the breaker the panel lit up as it should, gave me all the default info, I went through setup no problem, it turned on the pump ran, i cycled from speed 1 to 4 giving a minute at each speed, and checking psi on filter, and visually looking to see if water was successfully overflowing from spa back into pool as it would with my single speed pump.
Turned it off, came inside checked this website for tips on how to determine which speed to run at and how long etc.
went out side pressed speed 1 and it failed to start, pump basket is full of water, pump was already primed, it had worked.
the display says Drive Error, Pump has stalled.
I tried a few times, killed breaker waited 10 minutes powered up again and tried again, same result.
is my new pump defective??
any help on anything i should do besides yank it out take it back to leslies and demand a new one.
Thanks