Hi all,
This is my first posting here on TFP, so if I post like a newb please correct me.
This post is about my Polaris 380. Quite simply, the problem is the wheels aren't turning. It's only three years old and I can't seem to figure out what the solution is. Here's the steps I've taken (in chronological order) thus far:
- There was a significant amount of water coming from the pressure relief valve, purchased a new one and replaced it. That solved the issue with water coming from the valve.
- After further evaluation I noticed that only 2 of the 3 jets were working. I then took apart the whole unit to check out the water management system. I re-tightened the hose connected to the single jet which wasn't working. I then cleaned out all 3 jets with a paper clip. There was a lot of what seemed like white caulk\sealant\adhesive applied over most of hose to jet connections. It simply pulled right off and after reassembling the system, I re-applied a submersible silicone.
- Hooked every thing back up. The jets are now all working.
Still, no turning wheels.
If anyone could let me know where to go from here I'd really appreciate it. I'm determined to fix this thing myself at this point so I'm planning on ordering a rebuild kit and new water management system. Am I going in the right direction?
Thanks everyone,
- Patrick
This is my first posting here on TFP, so if I post like a newb please correct me.
This post is about my Polaris 380. Quite simply, the problem is the wheels aren't turning. It's only three years old and I can't seem to figure out what the solution is. Here's the steps I've taken (in chronological order) thus far:
- There was a significant amount of water coming from the pressure relief valve, purchased a new one and replaced it. That solved the issue with water coming from the valve.
- After further evaluation I noticed that only 2 of the 3 jets were working. I then took apart the whole unit to check out the water management system. I re-tightened the hose connected to the single jet which wasn't working. I then cleaned out all 3 jets with a paper clip. There was a lot of what seemed like white caulk\sealant\adhesive applied over most of hose to jet connections. It simply pulled right off and after reassembling the system, I re-applied a submersible silicone.
- Hooked every thing back up. The jets are now all working.
Still, no turning wheels.
If anyone could let me know where to go from here I'd really appreciate it. I'm determined to fix this thing myself at this point so I'm planning on ordering a rebuild kit and new water management system. Am I going in the right direction?
Thanks everyone,
- Patrick