I can't get my Intellifo VS to talk to the iAqualink.
I just had an Intelliflo VS installed and a Zodiac iAqualink running rev R software.
The pump replaced a constant speed pump on the filter relay.
As such, it works as a constant speed pump.
I attached the two wire control to one of the RS485 inputs on the Aqualink board. I attached yellow to yellow and green (well, more of an aqua) to green.
I told the software that I had an Intelliflo VS pump, and that it was for "filtering" and was pump one. The pump says that it's on address 1.
I put the pump in "Running Schedules" mode.
There's no indication that the wire is connected at all. I was expecting to see "Display Not Active" on the pump screen. doesn't happen. pump doesn't start. if I manually start the pump, the pump runs, but the AquaPure doesn't generate chlorine and the status shows the pump as offline. not sure what I need to do to get things running. Does the length of the RS-485 cable matter? It came with a really long cable, and I left it uncut.
On the Aqualink menu for VSP Speed Setup, I left all of the "Assign to AUX" as N/A. All of my AUX relays are already used and have nothing to do with the variable speeds.
Any suggestions? I'd really like to be able to control the speeds.
thanks,
Derek
I just had an Intelliflo VS installed and a Zodiac iAqualink running rev R software.
The pump replaced a constant speed pump on the filter relay.
As such, it works as a constant speed pump.
I attached the two wire control to one of the RS485 inputs on the Aqualink board. I attached yellow to yellow and green (well, more of an aqua) to green.
I told the software that I had an Intelliflo VS pump, and that it was for "filtering" and was pump one. The pump says that it's on address 1.
I put the pump in "Running Schedules" mode.
There's no indication that the wire is connected at all. I was expecting to see "Display Not Active" on the pump screen. doesn't happen. pump doesn't start. if I manually start the pump, the pump runs, but the AquaPure doesn't generate chlorine and the status shows the pump as offline. not sure what I need to do to get things running. Does the length of the RS-485 cable matter? It came with a really long cable, and I left it uncut.
On the Aqualink menu for VSP Speed Setup, I left all of the "Assign to AUX" as N/A. All of my AUX relays are already used and have nothing to do with the variable speeds.
Any suggestions? I'd really like to be able to control the speeds.
thanks,
Derek