Hi folks!
So, I think my Intellflo VF is brain dead. I suspect the pump and motor are fine, but the Control module is dead. I tested both Hot legs feeding the Module and I have power to the unit, but no LED readout at all and no function from the pump.
Couple questions...
1. Can I pull the control module and "hot wire" the motor temporarily to make sure the pump and motor are fine? Does anyone have access to the wiring diagram to the motor? There are only three leads. I just need to know which one is the neutral leg. Can the electric motor take the full load straight from the breaker?
2. Can I purchase just the control module only? How much? Where would I buy this? Is it worth it vs. just purchasing a whole new pump package.
The pump is almost exactly 4 years old now. It runs 24/7/365 and has been flawless up until this dead stop. No squealing bearings or running dry. Even if the pump or motor went bad, I'd still have an LED readout correct? I have nothing right now.
Thanks for your thoughts!
Jim
So, I think my Intellflo VF is brain dead. I suspect the pump and motor are fine, but the Control module is dead. I tested both Hot legs feeding the Module and I have power to the unit, but no LED readout at all and no function from the pump.
Couple questions...
1. Can I pull the control module and "hot wire" the motor temporarily to make sure the pump and motor are fine? Does anyone have access to the wiring diagram to the motor? There are only three leads. I just need to know which one is the neutral leg. Can the electric motor take the full load straight from the breaker?
2. Can I purchase just the control module only? How much? Where would I buy this? Is it worth it vs. just purchasing a whole new pump package.
The pump is almost exactly 4 years old now. It runs 24/7/365 and has been flawless up until this dead stop. No squealing bearings or running dry. Even if the pump or motor went bad, I'd still have an LED readout correct? I have nothing right now.
Thanks for your thoughts!
Jim