- May 4, 2010
- 12
I had a Warning Check Cell! light flashing for about a week. After checking the blades I noticed the outside two were shorter and ordered a replacement cell.
I installed it today and still get the same error message once in a while. I have it running on Cell power 2 in a 24 boost mode right now. It will randomly flash the same error message. It it is off and I test the pilot it will end up flashing. This is the latest pilot test readings...with no light flashing...
sc-48 (since there is not 42 for me to change to in install menu)
Salt 3,100
Temp 90
20v 4.1A ( it would flash with a 17v)
It is an rc-42 my pool is about 25k
What gets me is it is not all the time just every once in awhile like if the volts drop maybe. Tonigth the lights is flashing when the purifer is on only. sometimes it is and sometimes it's not. I had to replace several fuses inside after getting a low amp warning. I beleive it was to the cell fuses. Fuse in lower left corner i think?
Any idea on what this could be. It's a dig 220 serial # 0080709221
I installed it today and still get the same error message once in a while. I have it running on Cell power 2 in a 24 boost mode right now. It will randomly flash the same error message. It it is off and I test the pilot it will end up flashing. This is the latest pilot test readings...with no light flashing...
sc-48 (since there is not 42 for me to change to in install menu)
Salt 3,100
Temp 90
20v 4.1A ( it would flash with a 17v)
It is an rc-42 my pool is about 25k
What gets me is it is not all the time just every once in awhile like if the volts drop maybe. Tonigth the lights is flashing when the purifer is on only. sometimes it is and sometimes it's not. I had to replace several fuses inside after getting a low amp warning. I beleive it was to the cell fuses. Fuse in lower left corner i think?
Any idea on what this could be. It's a dig 220 serial # 0080709221