I have not been getting a reading on Cl so I took a look at the SWG. The display said it was generating...all solid green lights. (Aquarite). I ran the pump 8-9 hours in a 6500 gal. pool at 10%. Last year that would have put me over 5.0 for FC.
I used brand new reagents to test and still get 0.
Next day, no Cl, same green lights but this time I toggled through the digital display. According to the manual, the system will show 22-25 volts when making Cl, 30-35 volts when not....I show 31 V.
Cell current should be 4.5-7.8 when making Cl, I show 0. If I switch to superclorinate the readings as as they should be. When I switch back to normal mode the voltage is about 25 for 5-10 minutes and then swiched to 31.
I have no trouble lights or flashing lights. Cell looks good. Any ideas?
I used brand new reagents to test and still get 0.
Next day, no Cl, same green lights but this time I toggled through the digital display. According to the manual, the system will show 22-25 volts when making Cl, 30-35 volts when not....I show 31 V.
Cell current should be 4.5-7.8 when making Cl, I show 0. If I switch to superclorinate the readings as as they should be. When I switch back to normal mode the voltage is about 25 for 5-10 minutes and then swiched to 31.
I have no trouble lights or flashing lights. Cell looks good. Any ideas?