Greetings.
My new pool after filling with pipe water over Christmas now tested CH 60, CYA 0, ph7.8, TA80, FC2, CC0.5.
I have a few questions:
1) As my only source of CYA is from Trichlor and Calcium from Cal-hypo. I have switched my SWG off (for the time being until my CYA and CH are up normal). Both contain CL and both take time to bring the CYA and CH up. Which of the two should I bring up first or should I apply both.
2) Though my SWG is off but still connected to the plumbing, would there be any effect on the cells running on Trichlor and Cal-hypo over more than 6 months (that's the time frame needed to bring up CYA and CH). For your info, the nearest known source (to me) for Stabilizer and Calcium (for pool use) is Australia and it will take months to ship.
3) I sure read something about Cal-Hypo application somewhere in this forum but couldn't find it now, can someone point it out for me?
Thanks.
Vincent.
My new pool after filling with pipe water over Christmas now tested CH 60, CYA 0, ph7.8, TA80, FC2, CC0.5.
I have a few questions:
1) As my only source of CYA is from Trichlor and Calcium from Cal-hypo. I have switched my SWG off (for the time being until my CYA and CH are up normal). Both contain CL and both take time to bring the CYA and CH up. Which of the two should I bring up first or should I apply both.
2) Though my SWG is off but still connected to the plumbing, would there be any effect on the cells running on Trichlor and Cal-hypo over more than 6 months (that's the time frame needed to bring up CYA and CH). For your info, the nearest known source (to me) for Stabilizer and Calcium (for pool use) is Australia and it will take months to ship.
3) I sure read something about Cal-Hypo application somewhere in this forum but couldn't find it now, can someone point it out for me?
Thanks.
Vincent.