Good evening. I have an EasyTouch8 that I am trying to get to control an IntelliFlo VS+SVRS pump. I have run out of ideas and am stuck. Here's the basics:
I have the IntelliFlo VS+SVRS wired to Aux1
Activating Aux1 does provide power to the pump
I am able to manually turn the pump on with the Intelliflo panel on the pump
I have the pump configured as a 2-speed pump on the EasyFlow
I have configured Intelliflo pump#1 on the EasyFlow
The IntelliFlo VS+SVRS is a second pump in the system. The filter pump is a Whisperflo.
I have the RS485 port on the EasyTouch wired (ports 2-3) and the cable is plugged into the IntelliFlo VS+SVRS
The problem is, I cannot turn the IntelliFlo VS+SVRS on. When I have the pump running (manually from the Intellipro pump panel), the status within the EasyTouch Intellipro setup does not show me the rpms etc.. I do not think the 2 devices are communicating.
Can anyone shed some insight on where I could be going wrong?
Bob
I have the IntelliFlo VS+SVRS wired to Aux1
Activating Aux1 does provide power to the pump
I am able to manually turn the pump on with the Intelliflo panel on the pump
I have the pump configured as a 2-speed pump on the EasyFlow
I have configured Intelliflo pump#1 on the EasyFlow
The IntelliFlo VS+SVRS is a second pump in the system. The filter pump is a Whisperflo.
I have the RS485 port on the EasyTouch wired (ports 2-3) and the cable is plugged into the IntelliFlo VS+SVRS
The problem is, I cannot turn the IntelliFlo VS+SVRS on. When I have the pump running (manually from the Intellipro pump panel), the status within the EasyTouch Intellipro setup does not show me the rpms etc.. I do not think the 2 devices are communicating.
Can anyone shed some insight on where I could be going wrong?
Bob