- Jun 26, 2011
- 33
Ok, I had to replace the power supply box back in June because 4 capacitors had domed and one exploded. $581 later.
Now, I have been getting an intermittant flashing red light, 0ppm, and add 625 pounds of salt.
I had a new cord from the new box and it made no difference.
I cleaned the tri-sensor contacts with electrical contact cleaner and they are clean.
I am about to pull the tri-sensor out. I assume that the tri-sensor senses TEMP, FLOW and SALT level, correct? I have heard that the salt sensor can be dirty so I will clean it.
Does anyone know if I can test the salt sensor? Can I put an ohm meter on the salt sensor? Does anyone have the pinout?
Any ideas?, box it new, cord is new.
Anyone think its worth me removing the box and checking to make sure that the tri-sensor socket is soldered to the circuit board good?
Now, I have been getting an intermittant flashing red light, 0ppm, and add 625 pounds of salt.
I had a new cord from the new box and it made no difference.
I cleaned the tri-sensor contacts with electrical contact cleaner and they are clean.
I am about to pull the tri-sensor out. I assume that the tri-sensor senses TEMP, FLOW and SALT level, correct? I have heard that the salt sensor can be dirty so I will clean it.
Does anyone know if I can test the salt sensor? Can I put an ohm meter on the salt sensor? Does anyone have the pinout?
Any ideas?, box it new, cord is new.
Anyone think its worth me removing the box and checking to make sure that the tri-sensor socket is soldered to the circuit board good?