I'm haveing a Problem Changeing my Old Pool Light to new Intellibrite...
Looks like i have an old American Wet Pool Light Niche now known as Amerilit since Pentair purchased the company.
Pentair tech informed me that Intellibrite should work with this housing.
In comparing the old vs, new light everything looks like a good match that way.
My issue is this............I dissconected the old wires at thr wet niche housing juntion box. The box of course is a bronze unit connected to a piece of bronze conduit which is attached to the wet niche. I can't seem to pull the wire out. I'm wondering if there is a crimp type gromet at the wet niche point where the conduit enters. How is this point normally sealed from the pool water escaping. I may have to drain the pool to below this point just to be able to work in there.
Anyone with experience with this?? Shure could use the help............Cheers
Looks like i have an old American Wet Pool Light Niche now known as Amerilit since Pentair purchased the company.
Pentair tech informed me that Intellibrite should work with this housing.
In comparing the old vs, new light everything looks like a good match that way.
My issue is this............I dissconected the old wires at thr wet niche housing juntion box. The box of course is a bronze unit connected to a piece of bronze conduit which is attached to the wet niche. I can't seem to pull the wire out. I'm wondering if there is a crimp type gromet at the wet niche point where the conduit enters. How is this point normally sealed from the pool water escaping. I may have to drain the pool to below this point just to be able to work in there.
Anyone with experience with this?? Shure could use the help............Cheers