Hello:
I have been following this forum (and reading "Pool School") for the past 3 months. Thanks for all the info!!
We just completed an install of a new 16 x 32 vinyl pool, approx 17k gallons, (w/ AutoPilot SWG, AquaCal Heat Pump, StaRite Cartridge Filter) and have a few questions.
Pool was filled 2 days ago by truck and SWG/Pump/Filter started yesterday. Pump was is set to run 8am-5pm. Pool is in the sun most of the day. I inquired about Stabilizer, however, the PB was confident we do not need any.
I prepurchased a TF100 Kit and took some readings this afternoon.
FC 0
CYA 0
PH 7.2
TA 80
Salt is approx 3700ppm
I just set the Pump/SWG to run 24hrs with Boost on High and plan to take readings tomorrow afternoon again.
I am concerned about the FC reading 0 and CYA at 0. Should I just wait a few more days before doing anything?? Also, what about Ph, is 7.2 to low?
Thanks again for everyones insight.
I have been following this forum (and reading "Pool School") for the past 3 months. Thanks for all the info!!
We just completed an install of a new 16 x 32 vinyl pool, approx 17k gallons, (w/ AutoPilot SWG, AquaCal Heat Pump, StaRite Cartridge Filter) and have a few questions.
Pool was filled 2 days ago by truck and SWG/Pump/Filter started yesterday. Pump was is set to run 8am-5pm. Pool is in the sun most of the day. I inquired about Stabilizer, however, the PB was confident we do not need any.
I prepurchased a TF100 Kit and took some readings this afternoon.
FC 0
CYA 0
PH 7.2
TA 80
Salt is approx 3700ppm
I just set the Pump/SWG to run 24hrs with Boost on High and plan to take readings tomorrow afternoon again.
I am concerned about the FC reading 0 and CYA at 0. Should I just wait a few more days before doing anything?? Also, what about Ph, is 7.2 to low?
Thanks again for everyones insight.