Wanted to re-seal the barb to thread adapter on my Liquidator today (slow drip leak). Unfortunately when I went to unscrew the retainer from the outside the whole threaded piece snapped off from the float. Its a fairly clean break, Im thinking epoxy might work.......has anyone had success fixing something like this? Right now Im running without the "out" float in place........was able to get a nylon nut to hold the threaded piece and barb in the hole so the pool can at least be up and running for now.
Also, I know a while ago someone wondered if there is a generic replacement for any of the floats. Has anyone been able to find one? I couldnt find anything similar at McMaster.com which is usually my source for these things, and I was very surprised at that!
Also, I know a while ago someone wondered if there is a generic replacement for any of the floats. Has anyone been able to find one? I couldnt find anything similar at McMaster.com which is usually my source for these things, and I was very surprised at that!