I recentlu installed an Aqua rite T-3 SWG system and m very happy with it. It stopped chlorinating aan I went through the readings. All seem OK accept the voltage is 25.5 and the current is low at 2.73. I did let the system run for awhile before I took the readings. Salt is 3100, temp is 82 f, chlorinating light is on,and dial is set @ 100% and reading is showing 100%. Could a cell cleaning raise the current? could I have reversed the power wires. I have had the system running for a month And, it was chlorinating. I tested daily and it was staying at 2 ppm.