I usaully get this when I add more salt. Usaully I try to get it right prior to installation but sometimes fall short of 3200ppm. I sometimes need to add another 80LB bag or two of salt. This sometimes causes a "Hi" reading. It goes away by the morning and everything is good and salt is up to 3200-3400.
However I've read that this could short out the PCB board or blow a fuse. Is this right? and if so how do we raise the salt level safely? btw I add salt to deep end around sides and not through the skimmer.
Any info is much appreciated.
Thanks!
However I've read that this could short out the PCB board or blow a fuse. Is this right? and if so how do we raise the salt level safely? btw I add salt to deep end around sides and not through the skimmer.
Any info is much appreciated.
Thanks!