Hello Gang, I'm about to take the leap into SWG. I'm tossed up about the aquarite and the compuchlor, but the real question is installation. I have about a 1' stretch that the puck feeder is mounted on (been puck-free for more than a year, thanks to this site). Envision an up-over-down configuration with 1' being the over segment. It's too short to mount the aquarite in-line on. The compu unit, since it will mount vertically, will fit.
But let's say I wanted to put the aquarite unit it? I'd have to put 6 90 degree joints in to accommodate the horizontal/end mounts on the unit (2 out, 2 up, 2 in). Would the 6 90 degree turns significantly slow flow?
Sadly, I failed to get my degree in computational fluid dynamics. I WON'T MAKE THAT MISTAKE AGAIN!! Any takers on this one?
Thanks to all!
Jim.
But let's say I wanted to put the aquarite unit it? I'd have to put 6 90 degree joints in to accommodate the horizontal/end mounts on the unit (2 out, 2 up, 2 in). Would the 6 90 degree turns significantly slow flow?
Sadly, I failed to get my degree in computational fluid dynamics. I WON'T MAKE THAT MISTAKE AGAIN!! Any takers on this one?
Thanks to all!
Jim.