Hi Guys
I have just started looking after a pool. It is 100,000 litres, tiled and has a 2hp pump running a 36inch filter with a swg (aquablue)
Problem is the guy uses a seawater well to fill it with.
The Pool had not run since october and was a mess.
I have got it clean now and turned on the swg and it does not seem too bad
levels are
ph 7.4
alk 108
calcium hardness 387
cya 38
oh and salt lots!!!
Obviously his equpment is gonna get wrecked, but does anyone have any advice they could give me ref running this setup. I have the swg on 100% but it does not seem to be maintaing levels at all, it does have the high salt indicator on.
Many regards
Andy
I have just started looking after a pool. It is 100,000 litres, tiled and has a 2hp pump running a 36inch filter with a swg (aquablue)
Problem is the guy uses a seawater well to fill it with.
The Pool had not run since october and was a mess.
I have got it clean now and turned on the swg and it does not seem too bad
levels are
ph 7.4
alk 108
calcium hardness 387
cya 38
oh and salt lots!!!
Obviously his equpment is gonna get wrecked, but does anyone have any advice they could give me ref running this setup. I have the swg on 100% but it does not seem to be maintaing levels at all, it does have the high salt indicator on.
Many regards
Andy