I had the salt system installed in 2009 and when I turned everything on the other day my panel says "inspect cell" normally i can just disconnect it, run some water through it and it resets.
What do I need to do? Should I clean it some how if so how? I will assume as long as it says inspect cell I am not generating salt??
Could it be the water temp is too cold? It is 53 degrees
Thanks in advance!
What do I need to do? Should I clean it some how if so how? I will assume as long as it says inspect cell I am not generating salt??
Could it be the water temp is too cold? It is 53 degrees
Thanks in advance!